![]() ![]() This programming mode is used to pre-program many devices or/and ISP mode cannot use due to the board design. Communicating between the programmer and the device is done in parallel programming commands, so that the programing speed is two times faster than ISP mode. AVR has two different programming modes called Parallel Programming Mode (Parallel Mode) and Serial Downloading Mode (ISP mode).Īt the Parallel Mode, the device to be programmed is put on the programmer's socket and +12 volts programming voltage is required to its RESET pin.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |